1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 56Get this manual
6Reposition fuel" manifold to make room for the routing of electrical cables7Remove fuel connector bracket and lay to the side of the lower engine cover
[] 8Route the power tilt and trim cable past starter and opening in lower cover and air silencer[] 9Route battery cables in the same manner with the narrow side of the cable facing down[] 10Route remote control electrical harness into lower motor coverPosition harness and connector so they will not interfere with the upper motor cover when installed11Route the VRO tank wires along the same path[]] 12Raise grommet to expose slotLeave power tilt and trim motor wire and sleeve assembly in position in the grommet