1995 Johnson/Evinrude Outboards 40 thru 55 2-Cylinder Service Manual, Page 45Get this manual
Throttle Control Rod 1With the engine not running, ensure that the idle speed screw is firmly against its stop and both carburetor throttle plates are closed [I]
0.020 in(O,5 mm) gap between the throttle cam and cam
2Rotate the socket on the throttle control rod to obtain a
follower
3Install the throttle control rod socket on throttle cam and verify gapWide Open Throttle Stop
[[] 1Advance the throttle lever
open position
rn 2Thewide open throttleshaft pins must be exactly carburetor throttle vertical at
[[] 3Loosen the locknut and adjust the .O.Tstop screw to adjust pin orientation to exactly vertical
rn 4.throttlethe locknut and recheck pin orientation at wide Tighten open