1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 226Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 226

Starter Circuit CheckAll Models Note

I Battery must be fully chargedStep Procedure Remove black lead from ground at G) Connect voltmeter between G) and common engine groundTurn key to START positionVoltmeter should show battery voltageConnect meter at Turn key to START positionResult aIf no reading, go to Step

Check voltage between ground and G)

Steps thru Remove starter to solenoid cable from to prevent starter engagement while making checks

bIf meter reads battery voltage, reconnect black lead to ground and go to Step

Check voltage between ground

aIf meter reads battery voltage, lead is open between G) and

Note Steps thru Turn key OFF before connecting and disconnecting meterTurn key to START position after connecting

bIf no reading, go to Step

Back to 1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual