1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 216Get this manual
[]] 5Remove the retaining ring, and lift the pawl and links as an assembly [[] In6Hold the spindle nut under the housing, and remove
the spindle screw, nut, and spindleHold pulley in place to prevent starter spring from coming loose
In7Hold the pulley in the starter housing while turning the
Cleaning and Inspection
starter over, right side upHold fingers clear of the pulley, and jar the starter housing against bench to dislodge the rewind spring and pulley
1Wash metal components in solvent and dry with compressed air2Inspect the rewind spring for cracked or broken end loops3Examine the pawl for wear, and inspect the links4Remove starter rope from pulleyInspect rope and replace if frayedCut new rope 59 in(150 em) longFuse 112 in(12 mm) of both ends and pull through towel to make threading rope through holes easier5Examine the pulley and the starter housingLook for sharp edges and rough surfaces that could fray the starter ropeFile and polish to remove6Examine starter lockout partsReplace any worn or damaged parts, Assembly