1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 201Get this manual
Assembly
INote Make no dry assemblies
Lubricate bearings, shafts, and gears with OMC Ultra-HPF gearcase lube
1Oil and install new bearing in aft end of the bearing housing using OMC Bearing Installer, PI 335820Press against the lettered side of the bearing to prevent damage to the bearing when installingPress the bearing into the housing until the tool is seated on the housing
2Oil and install new bearing in the forward end of the bearing housing using OMC Bearing Installer, PIN 321428Press against the lettered side of the bearing until the tool is seated on the bearing housing
rn rnusing OMCnew seals back PI Nback in aft Apply OMCbearing 3Install to end ofthe housing Seal Installer, 335821Gasket