1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 147Get this manual
55Install one crankcase oiling hose recirculating hoses CD to the powerhead
and three
56Install all carburetion, ignition, and electrical components on the powerhead following instructions found in their respective sectionsInstallationTiller Models]1Coat both sides of new powerhead base gasket with OMC Gasket Sealing Compound and install it on the exhaust housing[] 2Coat the driveshaft splines Q) with OMC Moly LubeDo not apply lubricant to the end of the driveshaft as lubricant here may prevent seating of driveshaft in crankshaft
3Attach OMC Lifting Eye, PI 396748, to the flywheel and tighten the screws only enough to ensure thread engagement
INotel Threading the lifting eye screws in too far into the flywheel will damage components mounted to the underside of the flywheel