1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 136Get this manual
26Remove both center main bearings and split sleeves from the crankshaft for inspection27Remove crankcase seal rings for inspection
28Using an appropriate ring expander, remove all piston rings from pistonsDiscard the rings29Using tool as drawn on Page 4-6, remove all wrist pin retaining ringsDiscard retaining rings
rn 30Thefree thepin fit is from the both sidesPush Ifthe wrist pin wrist loose on through to piston connecting rodnecessary,
use OMC Wrist Pin Remover, PI 342657, to remove the wrist pin31Be careful not to lose any of the 24 needle bearings or the two wrist pin washersIf any of the bearings are worn or lost, replace all 24 bearings during reassembly
32Remove the neutral detent retaining ring using small screwdriverRemove the detent ball and springCleaning