1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 129Get this manual
7Remove the two screws securing the electrical connector cover to the engineRemove the cover[] 8Disconnect the stop switch wire connector Remove the stop switch wire from the ground stud]9Tiller Electric Models: Disconnect the 5-pin connector
10Tiller Electric Models: Use the appropriate Amphenol pin removal tool to remove the two neutral start switch wires from the connectorMake sure to identify the pin locations for installation during reassembly[] 11Tiller Electric Models: Remove the neutral start switch lead from the ground stud
12Remove the throttle cable ball socket Q) from the ball on the throttle lever using 0IVk:: Ball Socket Remover, PI 342226Remove the clip securing shift rod to shift leverRemove shift rod from lever13Remove the two screws block i!Y to the engine