1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 117Get this manual
STEPPOWER COIL TEST Ground Test 1Disconnect 4-pin Packard connector between stator and ignition module2Set peak-reading voltmeter to
[] 3Connect the meter black lead to clean engine groundAlternately connect meter red lead between the two orange stator leadsCrank engine and observe meter at each connectionAny reading indicates power coil is grounded Locate and repair ground, or replace stator assembly4If no reading is indicated in Step 3, go to Output TestOutput Test 1Set peak-reading voltmeter to
2Attach meter black lead to one orange stator leadAttach meter red lead to the other orange stator lead
3Crank engine and observe meter: If meter shows 100 volts or higher, go to STEPCHARGE COil TEST If meter shows less than 100 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test