1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 105Get this manual
[] 9Remove screw retaining the ignition coil to powerheadRemove coil with spark plug wireInstallation
1Apply CWIC Locquic Primer and CWIC Nut Lock to the ignition coil mounting screwPlace ignition coil in position and torque screw to 84-106 inIbs(9-12 Nm)
2Apply CWIC Locquic Primer and CWIC Nut Lock to three ignition module mounting screwsPlace ground wireQ) and lock washer under module mounting bossPosition the ignition module and torque screws to 84-106 inIbs(9-12 Nm)Place ground wire and lock washer into position and secure with screw CD tightened to 84-106 inIbs(9-12 Nm)3Install tanblack no-oil sender lead into 2-pin Amphenol connector using CWIC Insert Tool, PIN 322697Connect 4-pin Amphenol connector to engine harness and secure on ignition module4Attach three primary wires to ignition coils: orangebluetop coil orangepurplecenter coil orangegreenbottom coil