1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 62Get this manual
5To test the solenoid windings, calibrate an ohmmeter on low ohms scale and connect between the purplewhite and black leads Meter should indicate 5.5 1.5 ohms6To test solenoid valve and seat:
Lightly pressurize inlet fitting with alcohol and syringe With lever in run positionno fluid should enter inlet fitting With lever in prime positionfluid should come out both outlet fittings
[] 7To inspect or replace internal components, remove the four solenoid cover screws[] 8When assembling solenoid, back out screws in their holes to engage original threadsthen, tighten securelyInstallation 1Attach purplewhite leads and three hosesSecure large hose with tie strap2Install solenoid and bracketPosition ground lead under the inside bracket screw