1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 318Get this manual
30 C0A2439
bQuickly clamp the piston tightly in soft-jaw viseUsing breaker bar or sim ilar tool through the eyelet, unscrew the rod from the pistonAllow the piston to cool before removing from the viseThe four valves in the tilt piston are not serviceableIf the valves need replacement, the entire piston assembly will have to be replacedRemove any Locktite material left in the threads of the piston and the rod cSlide the tilt cylinder end cap off of the rodRemove and discard the outside a-ring from the end capUsing flat tool, pry the outside scraper from the end cap Discard the scraperdUsing the same tool, pry the -ring and back-up ring from the end capDiscard the a-ring eOil and install new a-ring and back-up ring in the end cap The square back-up ring goes above the a-ringfUse heat lamp or hot water to warm new scraperInstall the scraper in the end cap with the lip facing upgSecure the eyelet end of the rod in soft-jaw vise Using OMC Tilt Cylinder Seal Protector, PIN 326005, slide the end cap onto the rod in the direction shownPlace new outside a-ring on the end caphSpray the threads of the rod and the internal threads of the piston with OMC Locquic PrimerIn soft-jaw vise, secure the piston firmly with the smaller valve holes facing UPApply one or two drops of OMC Nut Lock to the threads of the rodThread the rod into the pistonTighten the rod securelyTry to avoid allowing the piston to slip in the soft jaws of the viseOil and install new outside a-ring on the piston8-60