1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 317Get this manual
23 C0A2433
1201 cUsing sharp screwdriver, pry the scraper out of the end
cap Discard the scraperdPry the O-ring out of the end cap using flat toolOnce the scraper and O-ring have been removed from the end cap, the outside O-ring can be removedClean the cap thoroughlyDiscard the O-rings
1221 eOil and install new O-ring and scraper CD in the end
capThe scraper is installed with the lip facing out and can easily be pressed in with your fingers or with large flat tool in the palm of your hand
COA2434
1231 Oil and install new O-ring Q) on the outside ofthe end cap1241 gUsing wire brush, clean all Locktlte material from the 1251 hClean the threads on the rod with
OMC Locquic PrimerSlide the piston onto the rodPlace new small O-ring over the threads
threads on the tilt rodUsing OMC Tilt Cylinder Seal Protector, PIN 326005, slide the end cap onto the rod