1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 223Get this manual
1 Assembly f1l 1If the reverse gate was removed during disassembly, install reverse gatebushingsand shafts to jet housingPosition shafts so holes align with holes where retaining screws make contactf1l 2Torque screws to 60-84 inIbs(7-9 Nm)After installation, check to make sure the reverse gate moves freely
'-=I assemble in any other position
f21 3Place roller into cam in position shownThe roller will not
f3l 4Place cam roller on reverse gate stud, and torque nut to 60-84 inIbs(7-9 Nm)5Install bushingeccentric nutand cam screw Before tightening cam screw, adjust reverse gateRefer to Gate Adjustmentf51 6Install water pump assembly to jet housingRefer to Water Pump Servicingf61 7Coat driveshaft splines with OMC Moly LubeDo not coat top surface of driveshaft as lubricant here may prevent seating of driveshaft in crankshaft