1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 204Get this manual
DR2061 DR2062
[] 6V4Install two new seals back to back in rear of the bearing housing using OMC Seal Installer, PI 326551Apply OMC Gasket Sealing Compound to metal casings of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing
7V6Install new seal in rear of the bearing housing using OMC Seal Installer, PIN 341439Apply oil to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease to the seal lips after installingCOA3559
[] 8Lightly apply OMC Triple-Guard grease to new bearing housing a-ringInstall the a-ring in its groove in the housing V4Install new seals on the retaining screwsDriveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged[] 1Remove the driveshaft bearing housing seal using OMC Puller Bridge, PI 432127, and OMC Large Puller Jaws, PIN 432129Discard the seal2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove