1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 193Get this manual
Propeller InstallationV4 i pellers; twist and remove all spark plug leads2Place engine's shift lever in NEUTRAL3Coat the propeller shaft splines sparingly with OMC TripeGuard grease
1Avoid accidental starting of engine while changing pro-
rv 4Place the thrust bushing shaftpropeller, then slide the in the assembly onto the propeller rv 6Install the propeller nutpin and tighten to propeller ofnut and torque 120 inIbs(14 Nm)If cotter holes in the
propeller shaft are not aligned, continue to tighten the nut until hey are in lineDo not loosen
GJ 5Install the thrust washer on the propeller shaft splines
rv 7Insert newends over the nut to secure the assemblyand cotter pin through the propeller nut shaftBend its
8Make sure engine is in NEUTRAL; give propeller spinIt must turn freely
Water Pump ServicingV4, V6
If the gearcase has been in service for any length of time, it is good policy to install water pump repair kitTo install the repair kit, proceed as follows: