1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 44Get this manual
Remote Control Cable InstallationEngine i cables are disconnected at batteryControl Cable Identification
To prevent accidental starting of engine, verify that battery
111 1Put the control handle into NEUTRAL positionThe throttle 111 2As you
cable casing guide will retract completely and the shift cable casing guide will go to the midpoint of its travelmove the control handle into FORWARD, the shift cable casing guide must retract and the throttle cable casing guide must begin to extend
3As you move the control handle into REVERSE, both casing guides must extend4Identify each control cable for proper installation
i before continuing with installationThrottle Cable
Control cable identification and function must be correct
1Remove the rubber grommet from front of lower engine coverRemove cable retainerApply liberal amount of OMC TripleGuard grease to both anchor block pocketsf2l' 2Extend throttle cable and lubricate with OMC Triple-Guard t=J grease3Verify that the fast idle lever is down in the RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustmentFailure to follow this procedure might cause accelerated wear of shift system components and high shifting effort5Move engine throttle lever tightly against idle stop screw