1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 289Get this manual
8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the pin of the pulley with the inner loop of the rewind spring and install the pulley in the starter housing
9Lightly apply OMC Triple-Guard grease or Lubriplate 777 to the spindle bushing and pawl pins on the pulleyInstall the bushing and the shim into the starter pulleyNext install the friction platelinks, and pawlsSecure the pawls with the retaining clips
10Light apply OMC Triple-Guard grease or Lubriplate 777to the spindleInstall the spindlefriction ringand two spring washers The flat section of the friction ring and spindle must be aligned
11Clean threads of the spindle retaining screw and nut to remove adhesiveInstall the spindle retaining screw and washer into the starter housingTighten screw to torque of 120-145 inIbs(14-16 Nm)Spray threads of spindle retaining screw that protrude through the starter housing with OMC Locquic PrimerApply OMC Nut Lock to the threads of the nutHold the spindle screw and torque the nut to 120-145 inIbs(14-16 Nm)