1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 285Get this manual
1121 5Let spring slowly unwind, turning pulley V2 to 1V2 revolu -
tions until rope anchor is opposite rope guide Insert Phillips screwdriver or long punch through pulley and starter housing to hold pulley in position against spring tension
f1i1 6Thread rope through handle and anchor retainer
Heat rope and press end flatPull knot tight and assemble knot into anchorand anchor into handle as shown
1141 7Thread rope through rope guide, and through pulley rim
and rope channel, to anchor point with sharp, hooked pinHeat rope and press end flatKnot rope and pull tight into anchor pointRemove tool holding pulley, and let spring slowly wind rope onto pulleyReinstall starter pawl components as an assemblyInstall E-ring with sharp edge up