1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 250Get this manual
COA3238
COA3239
COA3240
27Slide the retainer plate down the propeller shaft and into the gearcase with tab facing down28Using OMCRetaining Ring Pliers, PIN 331045, install the retaining ring into groove in gearcase with sharp outside edge facing aftThe retaining ring is under extreme pressure during installationWear safety glasses and proceed with care to avoid unsnapping the ring from the pliersLook inside the gearcase and make sure that the ring is seated in groove29Thread one OMC Guide Pin, PIN 383175into the retainer plateCOA3309
30Stick the reverse gear thrust washer to the back side of the propeller shaft bearing housing with OMC Needle Bearing Assembly Grease31Lightly apply OMC Gasket Sealing Compound to the aft support flange of the bearing housingAlign the propeller shaft bearing housing on the guide pin with the word "UP" toward the top32Using brass punch and mallet, seat the bearing housing in the gearcase