1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 246Get this manual
Assembly Make no dry assembliesLubricate bearings, shafts, and gears with OMC Utra-HPF gearcase lube
24 1Oil and install new bearing in aft end of the bearing housing using OMC Bearing Installer, PIN 335820Press
against the lettered side of the bearing to prevent damage to the bearing when installingPress the bearing into the housing until the tool is seated on the housing
1251 2Oil and install new bearing in the forward end of the bearing housing using OMC Bearing Installer, PIN 321428Press against the lettered side of the bearing until the tool is seated on the bearing housing
2611271 3Install new seals back to back in aft end ofthe bearing housing using OMC Seal Installer, PIN 335821Apply
OMC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing into the bearing housing and install the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing