1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 237Get this manual
1121 14Position the thrust bearingwasher on theother thrust one pinion thrust pinionOil and install Install the
on the pinion15Install the pinion in the gearcase
fN'=J If the pinion binds upon assembly, angle the forwa rd gear
to allow engagementIf binding is still present, the forward bearing cup is not properly seated
1141 16Pull shift rod up and install cradle on yoke r:;;;l 17Oil new a-ring and install on the pivot pinApply OMC Nut Lock to the threads of the pivot pinUse the yoke locator to locate the pivot pin hole in the yokeInstall and tighten the pivot pin to torque of 48-84 inIbs(5-9 Nm)
L!J Triple-Guard grease
r:;;l 18Coat the threaded area of the shift rod with OMC Slide the shift rod down through the shift rod bushing and thread it into the yoke until seatedThen back out shift rod until slotted face of connector faces the driveshaftf171 19Using long-nose pliers, place the clutch dog in the cradle with grooved side facing the forward gear