1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 211Get this manual
Isl 8Remove the three screws retaining the idle relief mufflerRemove the mufflerDiscard the muffler gasket and seals from the screws Inl r:;;J 9Remove the two remaining lower mount housing
screws from the port lower mount housingSeparate and remove the port and starboard lower mount housingSlide the mount housing bumper from between the lower front mount and the exhaust housing
f111 10Remove the nuts and washers from the two upper side mounts f121 11Remove the nut and the washer from the upper front mountSeparate the exhaust housing from the swivel bracket assemblyf131 12Remove the two screws retaining the lower motor cover bracket to the exhaust housing and remove the bracketRemove and discard the exhaust housing to lower engine cover seal
f11l f101 13Remove the upper side mount.s and the lower front
the exhaust housing
f101 14Remove the nuts from inside of the exhaust housing that retain both lower side mounts to the exhaust housing15Refer to Cleaning and Inspection at the beginning of this sectionAssembly and Installation If not otherwise specified, apply OMC Gasket Sealing Compound to threads of all screws