1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 176Get this manual
5The connecting rod has no specific orientationSupport the piston in OMC Piston Cradle, PIN 326573Oil the wrist pin bore and wrist pin1sl 6Install the wrist pin through the piston and connecting rod, pushing the tool out through the pistonr:;J 101 7Using OMC Cone, PIN 318600, and Driver, PIN 318599, install new wrist pin retaining rings in each wrist pin holeGap of the retaining ring faces down, away from notch in piston t!J
8Repeat Steps thru for each piston9Install piston rings on each pistonTapered ring must be installed in top grooveSpread each ring with ring expander just enough to slip it over the head ofthe piston and down into place
19l 10Clean the seal bore ofthe crankcase head and install new seal using OMC Installer, PIN 333520Apply OMC Gasket
Sealing Compound to the metal casing of the seal and press the seal into the crankcase head until the tool is seatedThe sharp edge of the seal's metal case must face the tool during installationLightly coat the seal lips with OMC Triple-Guard grease
r,()l 11To install new lower main bearing: Oil the end of the