1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 170Get this manual
1251 12Using tool as drawn on Page 4-9, or equivalent, push the taper pin toward the intake manifold surfaceDo not use any tool smaller than the taper pin bore to remove the pin1261 13Remove the six main bearing screws and eight flange screws1271 14Turn the powerhead with the intake facing up and then tap lightly upward on the crankshaft until the crankcase halves begin to separate15Lift the crankcase from the cylinder block12sl iNot Pist;ms, rods, rod and retamers are weanng parts and seat With the operation of the engineBecause of this, it is essential to maintain their original positions at reassemblyUsing an indelible ink marker, mark each connecting rod, cap, and bearing component when they are removed to ensure correct mating, and keep the needles of each cylinder togetherr:=lN Loosely install cylinder head to prevent pistons from falling 1291 16Remove the rod cap screws using OMC Torque Socket, PIN 331638Remove the cap's needle bearings and cages1301 17Lift the crankshaft out of the cylinder blockReplace the rod caps on the rodsOrient them exactly as they were before you removed themInstall the screws finger tight