1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 167Get this manual
r:;J 9Tiller modelsSeparate the 5-pin Amphenol connector LJ Remove the stop switch wire from terminal liE"Remove stop
switch ground wire from ignition coil
1sl10Remove the shift leverInsert paper clip into plunger and remove the pin and washer from the actuator cam linkDisengage the link from the shift actuator cam 11Remove the ground lead from the powerhead
Igl r,Ql12Using
OMC Special 12 inBox Wrench, PIN 322700, remove port and starboard powerhead retaining nuts with washers
r:t1l13Remove the four screws retaining the powerhead to the exhaust housing112l14The powerhead now can be removedIt may be necessary to rock the powerhead sideways to break the gasket looser;3l15Remove the inner exhaust tube from the powerhead and discard the gasket 16Place the powerhead in suitable holding fixture and remove all carburetor, ignition, and electrical components from the powerheadTo simplify reassembly and wiring installation, lay out the various screws and clamps in order of their proper location