1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 302Get this manual
Installation
1Place trimtilt unit into positionApply OMC Triple-Guard grease to the lower pin, and install the pin2Install external snap rings in lower pin with sharp edge of ring facing out3Extend tilt cylinder rod to match with holes in swivel bracket[!] 4Apply Triple-Guard grease to upper pin, and install the pin'2l 5I.nstall external snap rings onto upper pin with sharp edge t=I faci ng out] 6Attach ground wire to the motor retaining screwf41 7Route wires inside braided tube through stern bracket, and connect bullet and two pin connectors