1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 301Get this manual
7Attach reservoir to cylinder body with three Pozidriv screwsTorque the screws to 35-52 inIbs(4-6 Nm)
rn 8.piston assemblies fullyin intovise, lubricate trim pistonsOMC With cylinder body and bodyFill cylinders with push
Power TrimlTilt and Power Steering Fluid[] 9Screw trim cylinder end caps into cylinder bodyUse OMC Trim Cylinder End Cap Removerllnstaller, PIN 436710, or OMC Universal Spanner Wrench, PIN 912084, to torque caps to 60-70 ftIbs(81-95 Nm)
10Lubricate tilt cylinder piston and push assembly fully into cylinderFill cylinder with fluid11Screw tilt cylinder end cap into cylinder bodyUse OMC Tilt Cylinder End Cap Removerllnstaller, PIN 326485, or OMC Universal Spanner Wrench, PIN 912084, to torque cap to 58-87 ftIbs(79-118 Nm)12Fill reservoir with fluidPut on cap and cycle unit several times(Only tilt cylinder will retract With the tilt cylinder extended, slowly open fill cap allowing air to escapeAdd fluid, as necessary, to bring level up to bottom of the fill cap holeOnce air is purged from unit, retract tilt cylinder