1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 254Get this manual
18 24056
Assembly If removed, apply OMC Locquic Primer and OMC Screw Lock to the brush card screws before installing1Place armature in framer:J81 2Apply OMC Pressure Grease to the brush holder cap armature bearing3Correctly route the brush leads and install the springs and brushesINotellncorrect orientation of thebrushes could damage the starter or cause reverse rotationf191 4knifethe brushes and springs with modified putty
5Align and place brush holder cap firmly on armature and slide putty knife out, making sure the brushes are retained properly
1201 Install thrust washer, and align and place end cap onto armature shaft1'211 7Apply OMC Locquic Primer and OMC Screw Lock to the threaded portion, and install the two thru boltsTorque to 50-60 inIbs(5,6-9 Nm)