1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 225Get this manual
Bearing Housing Assembly Servicing
1Remove water pump assembly from jet housing
2Remove four bearing housing retaining screws, and remove bearing housing assembly from jet housing
rn &.glasses and proceed with with retaining ring pliersWear 3Remove retaining ring care to avoid unsnapping the safety
ring from the pliers
[] 4Remove O-rings from housing and discard[] 5Warm bearing housing with propane torch to aid in removal of upper seal carrier
INote Do
damaged
not apply too much heat as seals or carrier may be
&6Allow bearing housing to cool until it is warm to the touchW 7Place bearing housing assembly in pressPress from the
impeller end of the driveshaft until the seal carrier is free from the housingContinue to press bearings and driveshaft from bearing housing