1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 215Get this manual
Assembly
INote Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection
1Assemble the following components of OMC Pinion Bearing Remover and Installer, PIN 391257, as shown:
-20 112 inHex Head Screw in0.0Flat Washer
PIN 326584 Spacer PIN 326574 InstallerlRemover PIN 326587 Washer (V16 1314 in0.0 PIN 391260 Plate and Bearing PIN 326582 Rod CD -20 1V4 inHex Head Screw
2Apply OMC Needle Bearing Assembly Grease to the 18 needle bearings and insert them into the bearing case3Place the bearing on the installer tool with the lettered side of the bearing facing the top of the gearcaseUse OMC Needle Bearing Assembly Grease to hold the bearing on the tool
INote Incorrect installation of the pinion bearing in the gearcase
drastically reduces the life of the bearingThe bearing is tapered so that when installed correctly, its shape compensates for stresses in the gearcase and allows full bearing contactWhenever gearcase is disassembled, the pinion bearing should be checked to ensure that it has been installed with the lettering facing up4Insert the tool with the bearing into the gearcaseDrive the bearing into the gearcase until the washer on the tool contacts the spacerRemove the toolUsing rag, remove any excess grease from surface of the needle bearings