1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 197Get this manual
6Use one of the following methods to install the water intake screen Drop it into the water intake cavity, and push it down as far as it will go with screwdriver or other suitable tool Install both halves and secure with two screws, one on either sidern
7lightly coat the detent ball and spring with OMC Needle Bearing Assembly GreaseFirst, insert the spring in the housing, then the ball8Wear safety glasses to avoid injuryFace the detent lever toward either side of the housingDepress the ball and spring with punch while pushing the detent lever into the housingOnce the detent lever is past the ball, rotate the lever toward the rear of the housing, then move the detent lever to engage NEUTRAL position]] 9V6Thoroughly grease the original 25 needles with OMC Needle Bearing Assembly Grease and place in the bearing case[] 10Face the narrow arms of the shifter toward the housing, then reach inside and attach it to the detent leverAlign the pivot holes and insert the retaining pin