1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 196Get this manual
11Check shimming by reassembling the driveshaft with shims and placing it back into the tool baseThe measurement between the gauge bar and the pinion should be 0.020 in(0,508 mm)12Remove the nut and pinion from the driveshaftAssembly
INote Before beginning assembly procedures, all gearcase com-
ponents must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection1Assemble the following components of OMC Pinion Bearing Remover and Installer, PIN 391257, as shownV4 -20 inHex Head Screw in0.0Flat Washer PIN 341437 Spacer PIN 391260 Plate PIN 326582 Rod PIN 3265741nstailerRemover -20 12 inHex Head ScrewNot component of PIN 391257 V6 -20 112 inHex Head Screw CD in0.0Flat Washer Q) PIN 326584 Spacer PIN 3265741nstallerRemover PIN 326587 Washer (116 in0.0 PIN 391260 Plate and Bearing PIN 326582 Rod -20 inHex Head Screw
2V6Apply OMC Needle Bearing Assembly Grease to the 18 needle bearings and insert them into the bearing case3V4, V6Place the bearing on the installer tool with the lettered side of the bearing facing the top of the gearcaseUse OMC Needle Bearing Assembly Grease to hold the bearing on the tool