1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 148Get this manual
14 35264
14Using OMC Cone, PIN 331913, and Driver, PIN 396747, install new wrist pin retaining rings in each wrist pin holeGap of retaining ring faces up, away from notch in piston15Repeat Steps 11 thru 14 for each piston16When all pistons and connecting rods are assembled, install piston ring setsInstall each piston ring set on the piston that was used to test the ring clearancesUil Notel Be sure gap of ring fits squarely around dowel pin
INote Before continuing, be certain all
OMC Gel-Seal II sealant has been removed from the cylinder block and crankcase mating flangesIf traces of hardened OMC Gel-Seal II sealant are left, main bearing misalignment might occurRefer to Cleaning, this section17Rotate cylinder block so that port cylinder head surface is facing up and horizontal to the floor
[]]] 18Coat pistons, rings, cylinder walls, and OMC Ring Compressor, PIN 336314 (PIN 336313 for oversize pistons), with Evinrude or Johnson Outboard Lubricant19Center connecting rod in piston and locate piston rings on dowel pinsSlide No.2 piston assembly into top cylinder while guiding connecting rod through cylinder block20Repeat Steps 18 and 19 for remaining pistons on port side