1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 125Get this manual
STEPCHARGE COIL TEST, V6 MODELS Ground Test 1Disconnect the starboard side connector between stator and power pack2Attach test adapter from Kit, PIN 434017, to stator connector3Set peak-reading voltmeter to "POS" and "500"
4Connect the meter black lead to clean engine groundAlternately connect meter red lead between brown, brownyellow stator leadsCrank engine and observe meter at each connection: Any reading indicates charge coil is grounded Locate and repair ground, or replace stator assembly
5Repeat Step using brownblack and brownwhite stator leads6If no reading is indicated in Steps or 5, go to Output TestOutput Test 1Set peak-reading voltmeter to "POS" and" 500"
2Attach meter black lead to brown stator leadAttach meter red lead to the brownyellow stator
3Crank engine and observe meter4Repeat Steps and with meter black lead attached to brownblack stator lead and meter red lead attached to brownwhite stator lead: If meter shows 150 volts or higher, go to next step indicated in Troubleshooting Sequence Chart, Page 3-24 If meter shows less than 150 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test