1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 104Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 104

Installation
INote Remove any varnish from both sides ofthe stator retaining

screw holesThe stator must have metal to metal contact with the cylinder block and its retaining screws
[]] 1Guide the connector wires through the hole in the cylinder block, align the stator roll pin with the hole in the cylinder block, and seat the stator

2Seat grommet in hole in cylinder block
[]] 3Remove old adhesive from threads of the stator screwsPrime with OMC Locquic Primer and let dryApply OMC Nut Lock to threadsInstall the screws and tighten to 120-144 in.lbs(14-16 Nm)[] 4Using tie straps, secure the stator wiring harness to the engine wiring harness

Back to 1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151