1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 83Get this manual
9Clip float valve to floatInstall float assemblyTighten hinge pin retaining screw securelyInstall float bowl gasket
1341 10Adjust float heig ht with
carbu retor body invertedFloat must be level with gasket surface 132 in(0,8 mm)If adjustment is required, do not put pressure on float valve and seat
11Adjust the float drop with carburetor body in normal positionThe drop dimension to bottom of float should be between V16-11fs in(17-28 mm)12Install high speed fuel orifice with OMC Driver, PIN 317002, and install float chamber plugTorque plug to 30-35 inIbs(3-4 Nm)
and retaining screwsBack out screws in their holes to engage original threadsTorque screws in sequence to 18-24 inIbs(2-3 Nm)