1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 71Get this manual
Inspection ohms scale and connect between the purplewhite and black leads Meter should indicate 5.5 1.5 ohms2To test solenoid valve and seat: Lightly pressurize inlet fitting with alcohol and syringe With lever in run position fitting Isl lTo test the solenoid windings, calibrate an ohmmeter on low
, no fluidfluid
should enter inlet should come out
With lever in prime position both outlet fittings
19l 3To inspect or replace internal components, remove the four
t=J solenoid cover screwsGQl 4When assembling solenoid, back out screws in their holes to engage original threadsthen, tighten securelyInstallation 1Carefully, install the two primer hoses on the pump2Secure the pump to the component bracketTighten the two screws to 18-24 inIbs(2-3 Nm)3Connect the primer solenoid's two bullet connectors