1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 292Get this manual
Stator Resistance Check12 Amp Models c=J Disconnect battery cables before proceeding with this
N checkf311Disconnect stator yellow and yellowgray leads from termiboardf312Calibrate ohmmeter on appropriate scaleConnect one ohmmeter lead to stator yellow lead and the other ohmmeter lead to stator yellowgray lead Ohmmeter should show 0.40.6 ohm Repair or replace stator if reading is not correct3To check for grounded condition, disconnect both ohmmeter leadsCalibrate ohmmeter on appropriate scaleConnect one ohmmeter lead to clean engine ground and the other ohmmeter lead alternately to both stator leads Ohmmeter should show high reading If ohmmeter shows low reading, stator is grounded and should be repaired or replacedAfter replacing the stator and charge coil assembly, verify correct maximum spark advance using the procedure outlined in Section 1DR4133