1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 223Get this manual
12 15515
up, insert wedge end of the tool with flat side facing end of detent springWhen the tool is flush with the clutch dog, press the retaining pin through the clutch dog, pushing out the toolr:t3l 11Secure the pin with new retainer springPosition three coils over each end of the pin, making certain no coils of the spring overlap
f11l f121 1OWith holes in the clutch dog and shifter shaft lined
1141 12Install the forward gear thrust washer with chamfered edge facing into the gearcaser;;l 13Apply OMC Needle Bearing Assembly Grease to the forward gear thrust bearingPlace the bearing on shoulder of the gear and install the gear