1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 218Get this manual
Propeller Shaft Bearing Housing Servicing Inspect the bearings in placeIf bearing is removed for any reason, it must be replaced1To remove the two seals, front and rear bearings, use OMCBearing Puller PIN 432130 attached to either OMC Slide Hammer PIN 432128 or OMC Puller Bridge PIN 432127Thoroughly clean the housing in solvent2Install new bearings in the bearing housing using OMC Bearing Installer PIN 334997 Oil and place new forward bearing on the tool with lettered side of the bearing facing the too lInstall the bearing until the tool contacts the housing Oil and place new rear bearing on the tool with lettered side of the bearing facing the toolInstall the bearing until the tool contacts the housingr::;;1 r::;;;l 3Install new seals back to back in the rear of the 15500