1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 208Get this manual
Sealants and Lubricants Required
OMC Triple-Guard Grease OMC Gasket Sealing Compound OMC Adhesive TM OMC Moly Lube OMC Nut Lock OMC Ultra-HPFTM Gearcase Lube OMC Needle Bearing Assembly Grease
Service Aids Required
Stevens Gearcase Pressure Tester, $-34 Stevens Gearcase Vacuum Tester, V-34
Propeller Installation
i twist and remove all spark plug leads'" 1To avoid accidental starting of engine while servicing,
f1l 2Coat the propeller shaft splines sparingly with OMC TripleGuard grease3Place the thrust bushing in the propeller and then slide the assembly onto the propeller shaft4Install the thrust washer on splines of the propeller shaft5Install and tighten the propeller nut to torque of 120 in.lbs(14 Nm)Install new cotter pin or continue to tighten the nut to align the nearest cotter pin holeThe propeller shaft should turn freely (engine in NEUTRAL) after the propeller is installed6Install new cotter pinbending ends over the nutDR2477