1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 194Get this manual
Touch- Trim Servicing
J:The Touch-Trim TM unit must be serviced as complete assemblyNo detail parts are availableTo avoid personal injury, do not attempt to disassemble any part of hydraulic unitThe internal components and fluid are under high pressureCable Replacement 1Raise motor to full tilt position and engage tilt supportLower motor until tilt support rests on stern brackets
rv end from lever ballcable from holder and gently pry cable 2Remove Touch-Trim
3Remove cable nut
i blySTOP! Do not continue servicingCarefully screw
valve body back into cylinderRemove cylinder and cable as an assembly and replace
'" If valve body
starts to
unscrew from cylinder assem-
4Pull cable up and disconnect ball from slide valve socket5Remove cable from clamp and from cable block on stern bracketRetain cable nut