1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 140Get this manual
3Crank engine and observe meter reading: Rope or Amp 1.50 Volts 12Amp 0.5 Volt
PCE0068
If meter shows higher voltage, go to STEPPOWER PACK TEST If meter shows lower voltage, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test
Notel All ohmmeter tests must be performed with the engine NOT running1Calibrate ohmmeter on appropriate scale2Insert jumper wires in sensor coil terminals listed in chart
Rope or Amp