1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 56Get this manual
6Reposition fuel manifold to make room for the routing of electrical cables7Remove fuel connector bracket and lay to the side of the lower engine coverr&18Route the power tilt and trim cable past starter and opening in lower cover and air silencerf719Route battery cables in the same manner with the narrow side of the cable facing down 'sl10Route remote control electrical harness into lower motor
coverPosition harness and connector so they will hot interfere with the upper motor cover when installed
11Route the VRO tank wires along the same path1nl12Raise grommet to expose slotLeave power tilt and trim motor wire and sleeve assembly in position in the grommet