1994 Johnson/Evinrude Electric outboards Service Manual, Page 93Get this manual
Installation
Wakefield Thermal Joint Compound to new resistorThe compound should fill all space between the resistor and the adapter, and it must be applied to the base of the adapter where the resistor is seated to provide effective heat transfer[] 2Install resistor with terminallR" positioned at the bottom[]] 3Connect motor tube wires to resistor bobbin as follows: Connect the greenwhite wire to terminal "GW" Connect the red wire to terminal"R" Connect the green wire to terminal "G"4Install motor as follows: [[] Install new O-ring
W []] 1Apply
groove of motorred and green wires of