1994 Johnson/Evinrude Electric outboards Service Manual, Page 52Get this manual
[] 12Connect second meter lead to GREENWHITE 18-Gawire at speed control switch terminal "3"Move speed control switch to speed The meter must show continuity If meter shows no continuity, refer to Speed Control Switch, Page 2-12Continuity TestPositive CircuitHBF2 Note To avoid damaging components or troubleshooting equipment, disconnect the battery cables before proceeding1Use an ohmmeter calibrated on high ohms scale or continuity light to test continuity2Connect one meter lead to electric outboard positive RED battery cableLeave this meter lead connected for all the following tests [IJ
3Remove bottom cover plate from pedal baseConnect second meter lead to pin that will pierce wire at spliceTest for continuity at both sides of splice in RED lead in pedal base:
Meter must show continuity If meter shows no continuity, repair or replace battery cable connection
INotel Completely reseal wire at test area with OMC Black Neoprene Dip