1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 327Get this manual
11Oil and install the valve Thread the valve all the way Into the manifold Tighten the valve to torque of 45-55 in.lbs(5-6 Nm)Using OMCRetaining Ring Pliers, PIN 303857, install the retaining ring with the sharp edge of the ring facing outf121 12Oil and install the trim-up relief valve seat and O-ringPlace the core and spring in the seatf131 13Place the steel ball in the manifoldOil and install new filter valve seat and O-ring in the position shown14 14Insert the filter up through the manifold plate Using the three screws, flat washers, and lock washers, secure the manifold plate to the manifoldTighten the three screws evenly so that the plate does not become cockedTighten the screws to torque of 25-30 inIbs(2,8-3,4 Nm)15Clean the oil reservoirInstall new O-ring on the reservoirr:w5l 16Position the oil reservoir on the manifoldInstall the three retaining screws with lock washersTighten the three screws securelyf161 17Oil the components of the expansion relief valveUsing your thumb, press the valve seat CD and O-ring into the manifoldThen, press the valve core Q) and O-rings into the seatInsert the spring into the valve coref171 18Insert the trim-down pump relief valve and spring the manifold in the pO,sition shown