1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 299Get this manual
Trim Sending Unit Adjustment 1Tilt the engine and engage the mooring bracket
2Temporarily, install PIN 387278 thrust rod in the No.3
t=I sending unit can be pivoted
f213Loosen the sending unit screws
until only snug, so the
4Disengage the mooring bracketLower the engine against the thrust rodfil5Observe the trim gaugeIf the needle does not show center positiontilt the engine up and adjust the sending unit by pivoting it up or down6Lower the engine against the thrust rod to verify adjustmentRepeat Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the thrust rod