1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 296Get this manual
f71 7Attach reservoir to cylinder body with three PozidrivscrewsTorque the screws to 35-52 inIbs(4-6 Nm)
19l 8With cylinder body in vise, lubricate trim pistons and push
piston assemblies fully into bodyFill cylinders with OMC Power TrimlTilt and Power Steering Fluid
1nl 9Screw trim cylinder end caps into cylinder bodyUse OMC Trim Cylinder End Cap Removerllnstaller, PIN 436710, or OMC Universal Spanner Wrench, PIN 912084, to torque caps to 60-70 ftIbs(81 -95 Nm)f1Ol 10Lubricate tilt cylinder piston and push assembly fully into cylinderFill cylinder with fluidf111 11Screw tilt cylinder end cap into cylinder bodyUse OMC Tilt Cylinder End Cap Removerl lnstaller, PIN 326485, or OMC Universal Spanner Wrench, PIN 912084 to torque cap to 58-87 ftIbs(79-118 Nm)r:j2l 12Fill reservoir with fluidPut on cap and cycle unit several times(Only tilt cylinder will retract Check fluid level with cylinders extendedRetract tilt cylinder13Check bushings in cylinder body and replace, if worn